SMC Networks 2552W-G2, User Manual

Page: 158 / 294

Command Line Interface
6-20
6
APmgmtIP
This command specifies the client IP addresses that are allowed management
access to the access point through various protocols.
Caution: Secure Web (HTTPS) connections are not affected by the UI Management or
IP Management settings.
Syntax
APmgmtIP
<
multiple IP_address subnet_mask | single IP_address | any >
• multiple - Adds IP addresses within a specifiable range to the SNMP, web
and Telnet groups.
• single - Adds an IP address to the SNMP, web and Telnet groups.
• any - Allows any IP address access through SNMP, web and Telnet
groups.
• IP_address - Adds IP addresses to the SNMP, web and Telnet groups.
• subnet_mask - Specifies a range of IP addresses allowed management
access.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
• If anyone tries to access a management interface on the access point from
an invalid address, the unit will reject the connection, enter an event
message in the system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets of
addresses, either individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet),
the access point will not accept overlapping address ranges. When entering
addresses for different groups, the access point will accept overlapping
address ranges.
• You cannot delete an individual address from a specified range. You must
delete the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by
specifying both the start address and end address.
Example
This example restricts management access to the indicated addresses.
Enterprise AP(config)#apmgmtip multiple 192.168.1.50 255.255.255.0
Enterprise AP(config)#