Smarty
MADS
Page 7 of 16
Turn the ignition key to “OFF”. Press the ‘>’ key. Smarty will then ask you to switch the ignition key
“ON” in order to retry the connection:
Turn key ON
Press ‘>’
Turn the ignition key to the “RUN” position. DO NOT START THE ENGINE. Press the ‘>’ key.
When the connection has been established, Smarty shows the current installed software. During the
first
programming, the following screen will appear which indicates a STOCK ECM program is
installed:
Present SW:STOCK
Press ‘>’
Smarty will read the serial number of your vehicle and the serial number of your ECM, then store them
into its onboard memory for future reference. From this moment on, Smarty will work only with your
vehicle until your vehicle is restored back to the stock settings by Smarty.
Press the ‘>’ key. Smarty will ask you to select one of the CaTCHER software versions to load into the
ECM:
Choose CaTCHER
Press a # key
You can choose one of TEN different CaTCHER versions according to the desired performance. Enter
the single digit number (from 0 to 9), that corresponds with the software number to be programmed
into your ECM.
When you have entered the preferred CaTCHER software, Smarty asks if you want to adjust the speed
limiter of the truck. The speed limiter can be adjusted anywhere from 25 to 250 MPH in one MPH
steps.
IMPORTANT NOTICE
Your tires might not be rated for increased speeds. Please check your tires rating!
1=Adj.Speed lim.
2=Program SW: 5
You can return back one step, in any moment with the ‘<’ key
If you do not want to adjust the speed limiter, to start the updating session, press ‘2’.
To adjust the speed limiter, press ‘1’, the following page will appear::
Speed lim:xxx
New lim:___
When you have entered the speed limit, Smarty asks you to confirm the selection before he downloads
the new software into the ECM: (example software #5 has been entered):
Program SW: 5
Press ‘>’
Press the ‘<’ key to return back one step and enter a different software number.
Press the ‘>’ key to confirm your selection and to begin the updating session. You will see the
following screen:
PROGRAMMING
Please wait
