7
CHECK
TRACE
CONTROL
4.1 Mounting
The SmartPoint has a single mounting hole in the center of the casing. This can be used in various ways to attach the device to the
required surface (e.g. bolt, cord, or tie wrap).
Warning
: Avoid the use of metallic or magnetical materials for the mounting material.
Info
: The placement of the SmartPoint and/or the materials surrounding it, can have a (negative) impact on the radio range. Pre
-
vent the use of any metallic materials around the device. Install the device with an air gap of >4 cm from walls.
SL-SP-T/ERS mounting
Status: door closed
Status: door opened
MEDER
M
agen
t
M
04
H6 / 8
Model: SL-SP-T/ERS
Article No: 905-SMPT-024-016
00:0e
MEDER
M
agen
t
M04
H6 / 8
Model: SL-SP-T/ERS
Article No: 905-SMPT-024-016
00:0e
Install the SmartPoint T/ERS with external reed sensor as depicted above.
Warning
: Ensure that the external sensor cable cannot be pulled out of the device. Any force applied to the cable may cause da
-
mage, even if the damage is not visible from outside. The cable has limited pull relieve.
SL-SP-T/H and SL-SP-T/HO mounting
•
Ensure that proper airflow is possible around the relative air humidity sensor.
•
Do not block the opening of the sensor.
•
Keep the sensor clean. Dust and condensation on the sensor membrane can cause an unwanted effect on the sensor.
•
Do not spray water directly on the sensor opening. This may damage the membrane protecting the sensor and electronics.
Magnet
Magnet
Reed-
sensor
Reed-
sensor
Smart-
Point
T/ERS
Smart-
Point
T/ERS
Status: door closed
Status: door opened
User Manual
SmartPoint/SmartPoint One
