10
CHECK
TRACE
CONTROL
6. Important Information
6.1. Storage and active mode conditions
•
Before activation, the SmartPoint must be stored between 10°C and 25°C in a non-condensing environment.
•
After activation, acceptable operational temperature is –40°C to +85°C.
•
Do not expose the SmartPoint to mechanical impact/force exceeding the norm defined in EN 60068-2-31:2008 and EN 60068-2-
6:2008.
•
The SmartPoint has been designed to be resistant to moisture and dust conditions that can be expected in warehouses, during
transportation, storage in fridges/freezers etc. It has not been designed for outdoor use. Do not puncture the membrane of the
relative air humidity sensor.
Warning
: Do not fully submerge the product in water. Excessive exposure to direct sunlight may cause discoloration of the enclo
-
sure and/or reduction of the mechanical robustness. Do not use high-pressure cleaning directly on the SmartPoint. Do not use
chemicals to clean the SmartPoint.
6.2 Liability
The manufacturer shall not be held liable:
•
If the device was used beyond the manufacturer’s given limitations.
• For any claims due to the improper storage and use of the device.
•
For any problems with the temperature controlling and / or cooling unit.
•
For the bad quality of any monitored goods.
•
For incorrect readings if the device was used beyond its expiry date.
Warranty
: SmartPoint and SmartPoint One 1 year from date of delivery. Battery pack is excluded from warranty.
6.3 Battery
The SmartPoints contain a non-rechargeable Lithium battery. Please pay strict attention to the following points:
•
The housing of the SmartPoint must never be opened nor destroyed.
•
Never expose the SmartPoint to temperatures above the allowed range (fire, oven, microwaves, etc.).
It may cause serious injuries.
• Always keep the SmartPoint out of the reach of children.
•
The battery complies with IATA DGR Packaging Instruction 970 Section 2 and is therefore not considered as dangerous good.
Consult IATA regulation before use in airfreight.
•
Dispose or recycle the SmartPoint in accordance with the WEEE2012/19/EU guidelines or your local regulations.
The device may also be returned to the manufacturer for proper recycling.
7. Regulatory information
FCC INFORMATION (USA):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not
cause harmful interference, and 2. This device must accept any interference received, including interference that may cause un
-
desired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residenti
-
al installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio / TV technician for help.
Caution
: Any changes or modifications not expressly approved by the party responsible for compliance could void the user‘s
authority to operate this equipment.
User Manual
SmartPoint/SmartPoint One
