SmartGyro 106OM405, Operation Manual

Page: 32 / 52

28
GYRO STABILIZER OPERATION
SG60 Operation Manual
3. Press the Power (ON/OFF) icon (Figure 4,
(1)) to power on the gyro unit.
1
Figure 4
Note:
- When the power of the gyro unit is turned
on, the circle around the ON/OFF icon turns
green.
- When the gyro unit is powered, the flywheel
will start accelerating, the speed indication
marker will move along the dial on the
Home page, and the actual speed value will
be expressed as a percentage of full speed
and will increase over time. For details on
the display, see “Home Page” on page 14.
- If for any reason it is not possible to
turn on the stabilizer unit (for exam-
ple for a ‘no communication’ anomaly
on the CAN line between the motor
drive and the control board), the cir-
cle around the ON/OFF remains grey.
Check the details of the anomaly on the
alarm log page, see “Alarm Log Page” on
page 25.
- For information about displayed anomaly
messages and how to handle them, see
“TROUBLESHOOTING” on page 38.
4. Make sure the seawater and glycol pumps
are operating.
Note:
- If the seawater pump is connected to a cir-
cuit other than the gyro system, turn on the
power to operate the seawater pump.
- If you connect the seawater pump directly
to the gyro system, the system will also acti-
vate the seawater pump when the flywheel
reaches about 300 RPM (it takes about 3
minutes to reach this speed).
5. Press the night/day selection icon (Fig-
ure 5, (1)) to select the desired operating
speed.
1
Figure 5