SmartGyro 106OM405, Operation Manual

Page: 10 / 52

6
SAFETY
SG60 Operation Manual
CAUTION
Poor Lighting Hazard
Ensure that the work area is adequately illumi-
nated. Always install wire cages on portable
safety lamps.
Tool Hazard
Always use tools appropriate for the task at
hand and use the correct size tool for loosen-
ing or tightening machine parts.
Flying Object Hazard
Always wear eye protection
when servicing the gyro stabi-
lizer or when using compressed
air or high-pressure water. Dust,
flying debris, compressed air,
pressurized water or steam may injure your
eyes.
Coolant Hazard
Wear eye protection and rubber
gloves when you handle coolant
or hydraulic oil. If contact with
your eyes or skin occurs, clean
and wash it off immediately with clean water.
WARNING
Electrical Shock Hazard
- Inside the gyro unit
hazardous voltages are
present. For this reason the
cover must not be opened
when the gyro system is
running and AC power is connected. Also,
never disconnect the yellow/green
earthing/grounding cable, connected to
the ground stud.
- Before opening the cover be sure that the
AC mains supply is disconnected from the
gyro unit.
- Before operating the gyro stabilizer ALWAYS
ensure that the safety ground cable is se-
curely connected to the gyro base frame.
- The inverter box contains hazardous volt-
ages derived from the AC power line. When
inspecting the inside of the inverter box, be
sure to turn off the AC power supply.
- A potentially dangerous voltage is present
even if AC power is disconnected but the
flywheel is still rotating. Therefore, service
work on the inverter box is only permitted
when power is disconnected and the fly-
wheel has come to a complete stop.