SMART LightRaise Installation and User's Guide
25
To mount the brackets to a wall with wood or metal studs:
1
At each marked keyhole location, use the Phillips hand screwdriver to insert a self-drilling
drywall anchor. However, if any keyhole location is at a stud, you don't need to use a
drywall anchor.
2
Use the Phillips hand screwdriver to partially thread a #8 x 1¼" truss head screw into each
anchor, leaving ¼"
(6 mm)
of each screw exposed.
Truss Head Screw
Anchor (if applicable to your wall)
3
Hang the upper boom bracket on the highest set of screws, pushing the keyholes firmly
down over the protruding screws.
4
Hang the lower boom bracket on the middle set of screws, pushing the keyholes firmly
down over the protruding screws.
5
Hang the hanger bracket on the tabs of the lower boom bracket. For each row of slots on
the hanger bracket, mark two evenly spaced hole locations.
6
Hang the spacer bracket on the lowest set of screws, pushing the keyholes firmly down
over the protruding screws. Mark the two screw locations.
Illustration not to scale
Upper Boom
Bracket
Lower Boom
Bracket
Hanger Bracket
Spacer Bracket
Mark hole locations for hanger bracket
Screw Locations
IMPORTANT:
Don't use a
hammer to
insert the
drywall
anchors.
NOTE:
If your setup
doesn't include a
SMART Board
interactive white-
board, you don't
need to follow the
instructions for the
hanger and spacer
brackets.
