SMAR LD303, Operation And Maintenance Instruction Manual, Page: 68 / 110

LD303 - Operation and Maintenance Instruction Manual
3.42
;byte 09
Unit_Diag_Bit(88) = "Not used 88"
Unit_Diag_Bit(89) = "Not used 89"
Unit_Diag_Bit(90) = "Not used 90"
Unit_Diag_Bit(91) = "Not used 91"
Unit_Diag_Bit(92) = "Not used 92"
Unit_Diag_Bit(93) = "Not used 93"
Unit_Diag_Bit(94) = "Not used 94"
Unit_Diag_Bit(95) = "Not used 95"
;byte 10
Unit_Diag_Bit(96) = "Not used 96"
Unit_Diag_Bit(97) = "Not used 97"
Unit_Diag_Bit(98) = "Not used 98"
Unit_Diag_Bit(99) = "Not used 99"
Unit_Diag_Bit(100) = "Not used 100"
Unit_Diag_Bit(101) = "Not used 101"
Unit_Diag_Bit(102) = "Not used 102"
Unit_Diag_Bit(103) = "Not used 103"
NOTE
If the FIX flag is active on LCD, the
LD303
is configured to "Profile Specific" mode. When in
"Manufacturer Specific" mode, the Identifier Number is 0x0895. Once the
Identifier_Number_Selector is changed from "Profile Specific" to "Manufacturer Specific" or vice-
versa, one must wait 5 seconds while is saved. Then, turn the
LD303
off and turn it on again. So,
the Identifier Number is updated to the communication level. If the equipment is in "Profile
Specific" and using the GSD file Identifier Number equals 0x0895, the acyclic communication will
work with the tools based on EDDL, FDT/DTM, but no cyclic communication with the Profibus-DP
master.