16 9880023200-CU 36P NEUTRO 120312
CAUTION:
SOME CABINETS AND BUILDING MATERIALS ARE NOT
DESIGNED TO WITHSTAND THE HEAT PRODUCED BY THE NORMAL
SAFE OPERATION OF A LISTED APPLIANCE. DISCOLORATION OR
DAMAGE, SUCH AS DELAMINATION, MAY OCCUR.
LOCATING THE RANGE
Do not set range over holes in the floor or other locations where it may be
subject to strong drafts. Any opening in the wall behind the range and in the
floor under the range should be sealed. Make sure the flow of combustion or
ventilation air is not obstructed.
NOTE
:
A range should not be installed over kitchen carpeting.
VENTILATION
Ventilation must be in accordance with local installation code. The appliance
must be installed in a well-ventilated environment to guarantee a correct
combustion gases exchange, proper air circulation and working temperature
within safety limits.
MODEL NUMBER PLATE
The Model Number Plate is located in front oven surface, on right side. A
second Model Number Plate is applied on the front page of the instruction
booklet.
■
ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS
MOD: Oven Gas Range – Oven Dual Fuel Range
NOTE:
A risk of range tip over exists if the appliance is not installed in
accordance with the installation instructions provided. The proper use of this
device minimises the risk of TIPPING-OVER . In using this device the
consumer must still observe the safety precautions as stated in the Instruction
Manual and avoid using the oven door and/or lower drawer as a step stool.
Installation instructions are provided for wood and cement wall. Any other
type of construction may require special installation techniques as deemed
necessary to provide adequate fastening of the ANTI-TIP bracket to the wall.
STEP 1 – Locating The Bracket (see fig. 14)
A. Mark the wall from either the right or left rear “EDGE” of the range is to be
located.
B. Place the Anti-Tip Bracket 8 5/8” from the marked “EDGE” toward centre
of opening and against the back wall with a first hole height of 1 ¾” plus
“A” (distance between side wall bottom edge and floor after range
leveling) as shown in figure 14.
