SlimLine 9173B, Instruction Manual

Page: 21 / 44

Operation
9173B_002-286e-07.10 Page 19
5.5 Effect of Temperature
The temperature coefficient of the sensitivity (change in
sensitivity as a function of temperature, with the entire
SlimLine force link at the same temperature) is negligible.
However, changes in temperature during measurement re-
sult in an error signal in the form of a drift of the zero. This
temperature drift is a function of the quantity of heat in-
troduced. For critical applications, design measures protect-
ing the SlimLine force link against substantial temperature
fluctuations are recommended.
5.6 Tips for Good Measurement

Always store the measuring instruments in the room in
which measurement is performed.

Leave the connecting cable permanently connected to
both the sensor and the measuring instrument. If this is
not possible, put the protective caps back on the con-
nectors.

Mount the sensor exactly as specified.

Switch the measuring instrument on approximately one
hour before the first measurement.

Set the sensitivity of the sensor to the value specified on
the calibration certificate.

Choose the measuring range and scaling of the output
voltage to ensure the value of the maximum measure-
ment lies in the 50 to 100 % range.

Avoid changes in temperature during measurement.

Do not start the measurement process (Operate) until
just before the actual measurement.