68
9. Main menu
39746
39745
VI-3. Services Copy
In this menu, you can copy the existing channels between Tuner 1 and Tuner 2.
A. Tuner 1 to Tuner 2:
Copy the service list of Tuner 1 to that of Tuner 2.
B. Tuner 2 to Tuner 1:
Copy the service list of Tuner 2 to that of Tuner 1.
C. All:
Add the service lists of Tuner 1 and Tuner 2 and save it to service list
of Tuner 1 and that of Tuner 2.
VI-4. Motorized DiSEqC 1.2
If you have DiSEqC 1.2 motorized system, then you can use the DiSEqC 1.2 functions.
•
Satellite Name:
Select a satellite name that will be used to identify a
motor position.
•
Tuner Select:
Select a tuner that is connected with DiSEqC 1.2 system.
•
Transponder:
Select the transponder to catch the strong signal. Select
the TP from TP list box to get the strong signal.
•
LNB Setting:
Please refer to LNB setting of this chapter.
•
Motorized DiSEqC 1.2:
Select Enable or Disable. If you are using
DiSEqC 1.2 antenna, set to Enable.
•
DiSEqC Command Mode:
Change the current mode between User and
Installer modes.
User:
This mode is used to fine-tune the position of the motor for better reception.
Installer:
This mode is used to search for the position of a satellite manually.
• Movement:
In case of
User mode
, the movement is adjustable by fine-tuning.
In case of
Installer mode
, the movement is adjustable by East, West going command.
• Motor Control
Goto:
Move the motor to the stored position of the selected satellite.
Store:
Store the current position of the motor for the selected satellite.
* The followings are available only at the Installer mode.
Recalculate:
Recalculate the position of the Stab Rotor motor.
Goto Ref:
Go to reference.
Limit E, Limit W:
Set the limits of East and West position.
Limit Off:
Remove the limitation.
Reset:
Reset all the stored position of the motor relative to the “0” position
• Channel Search
After saving the DiSEqC configuration at the highest signal quality, press OK
button to start channel searching of the selected satellite.
VI-5. USALS Setting
USALS is very convenient motorized DiSEqC system that supports DiSEqC 1.3
command and also can get the satellite position automatically if you know
your geographical location. Basically, the listed satellites have its Longitude
and therefore the angle of the satellite can be calculated without problem.
If you have USALS motorized system, then you can use the USALS as followings.
•
Tuner Select:
Select a tuner that is connected with USALS system.
•
Motorized DiSEqC 1.3:
Select Enable or Disable. If you are using
DiSEqC1.3 switch, set to Enable.
•
Satellite Name:
Select a satellite that will be used to identify a motor system.
39746_BDA_0604_eng #38 29.06.2004 14:22 Uhr Seite 68
