Skymaster DVR 9200, Operating Instructions Manual

Page: 18 / 40

56
9. Main menu
39743
1.2.5 Add a satellite or TP (transponder)
Satellite name: Select the satellite to which you wish to add the TPs. If
you select “User”, you can add a new satellite.
LNB Freq. Low: Preferably select the setting “Universal”
(Low = 9750 and High = 10600 MHz). You may skip the next option
(
LNB Freq. High).
LNB Freq. High: Select the correct frequency of the LNB with the help of
the number keys if you are not using a normal Universal LNB.
Transponder: Select a new TP value with the help of the number keys.
Polarity: Select a value from (Hor/Ver/Left/Right) for exact polarity setting.
Symbol rate: Select a correct value with the number keys.
Save: Save the current settings.
1.3 Normal search
Select “Normal Search” from the Installation menu and confirm the selection
with “OK”. You can get more information about “Normal Search” from your
dealer, from the Internet or from satellite magazines.
Satellite name: Select the satellite on which the antenna is focused. If you
select “All Configured”, all satellites that you have configured in the
antenna settings will be searched.
TP Frequency: TP frequency values can be adjusted with “ ”, “ ”.
If you select “Auto”, all the channels of the satellite are searched.
Polarity Symbol rate: If the “TP Frequency” value is set, the values of
“Polarity” and “Symbol Rate” are set automatically.
Network search: Select “Yes” or “No” with the “ ”, “ ” keys. If you
select “Yes”, you will get a current transponder list of the satellite carrier.
Unfortunately, this meaningful service is not yet being supported by all
the satellite carriers.
Search Mode:
“FTA-ADD/ALL-ADD”: Add new content (free / all channels) at the end of
the list.
FTA_OVERWRITE/ALL_OVERWRITE“: Overwrite all data received thus far
by the satellite and replace them with a new programme list.
Go To: If a pre-set position of the antenna exists, it sets the antenna on
this position.