Assembly & Operation Manual
ARF Paint
The color finish on your Skymaster Phanter arf pro model was applied out of the mould. We have used
only the highest standard automotive paints to finish your model.
Should you damage the finish, Skymaster stock the color paint and hardener required for the repair. A
good automotive spray painter should also be able to mix and supply the correct samples for repair.
If you have no experience in the use of these paints, it will be best to seek assistance.
Do not leave your model unprotected in the sun! always cover your model or park it in the shade. Ex-
treme temperatures will damage the paint
!
Finishing Your All White Panther ARF PRO
It is always best to fully assemble the model before painting. By doing so no damage or glue prints will
ruin the paint.
The all white model will have some release agent on the surfaces.
Use #1000 wet and dry paper to sand the entire model. Mould lines can be sanded and filled using nor-
mal automotive fillers.
Please be extra careful when sanding near the hinge line! The hinges can easily be damaged. When
masking and painting please make sure the control surfaces are not bend past 90—180 degrees exten-
sively. This will cause the hinges to crack and may cause flutter.
The rudder and clear canopy are not installed. It is best to install these components after painting was
done.
P-4
