Assembly & Operation Manual
STABILIZER
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. Mark √ each step.
Fit 4 x L-brackets to 2 x 8511 servos. Servo‟s mirror image of each other.
Fit servo horns and adjust travel and sub-trim with TX.
Fit mounting blocks to L-brackets. Drill pilot holes. This will stop the wood cracking.
Feed wire through holes and glue mounting blocks to skin. Make sure the skin was
rough. Use #80 grit to scratch the skin. (NOTE: I wanted to fit STD size servos. I
had to glass the skin for extra strength. If using smaller servos—glue a ply base
plate to skin. Then glue servo mount blocks to ply.
Mask area for elevator horn. Draw a line perpendicular across hinge line.
Mark location of horns. (Note shape of horns). Dremel slot for horns.
Glue horns using 5 min epoxy. (Note—make sure balsa support inside elevator).
Fit pushrods to servo horns and elevator horn. Repeat for other elevator.
Cut hole for servo wire in skin. Cut slot in servo covers and secure.
P-15
Photo 27
Photo 28
Photo 29
Photo 30
Photo 31
Photo 32
