Assembly & Operation Manual
FIN STAB & RUDDER
NOTE:
Make sure to have some sort of protective foam on the work bench. This will
protect the paint surface from unwanted dents. Mark √ each step.
Fit DS8711 servo to mount and drill 4 pilot holes. Make sure servo is centered be-
fore you screw it in position.
Cut slots either side of servo for servo horn.
Fit horn and check operation.
Fit extension lead to rudder cable.
Feed the 2 elevator cables through hole in fin root and bolt stab in position. Use 3
cap srews as supplied.
Trial fit the rudder fearing and dremel 1/2 circle to clear rudder post.
Fit fin and tighten the clamps.
Make up rudder belcrank. Use 50mm 3mm threaded rod and stick it through hole
in rudder post. Use locktide to secure rod with bolt on either side of post.
Now fit the 2 plastic horns at each end.
P-16
Photo 33
Photo 34
Photo 35
Photo 38
Photo 37
Photo 36
