Secure extension wire. Use safety clips on joint.
Mask off area for aileron horn.
Draw a line perpendicular to hinge line.
Mark off area for aileron horn.
Draw a line on hinge line when aileron is in down
position. This will be the front of horn location.
Use dremel tool to cut slot. NB Make sure the horn is
supported by balsa inside the aileron. If no wood inside
aileron, cut slot in LE spar of aileron (just above hinge
line) and insert 10 x 10 blasa stick. CA in position.
Glue horn in place.
Fit pushrod. Mark location for cover and secure in
position.
P-13
Assembly & Operation Manual
Photo 19
Photo 20
Photo 21
Photo 22
