46
FOLDING HANDLE
1. To unfold the switch handle, depress the middle
control knob (on the left side) and rotate the upper
arm 180° counterclockwise. When fully open, the
control knob will click out in the locked position.
2. Depress the lower control knob (on the right side)
and rotate the arm assembly 130° clockwise. When
correctly positioned, the control knob will click out
in the locked position; the arm assembly will be at
an approximate 50° angle.
3. To extend the switch handle, loosen the control
knob on the top of the arm assembly. Slide the
switch handle out to one of the five preset detent
positions, and then tighten the control knob.
4. Assemble the side handle onto the desired position
(left or right side) by rotating the handle clockwise
into the threaded insert.
Interruptor
When starting the
tool, hold the switch
handle with one hand and the side handle with the
other. Tip the tool back on the two rear wheels. The
tool should be in the UP position with the cut-off
wheel above the material to be cut.
The torque from
the motor can cause the tool to twist.
Para ENCENDER la herramienta, comprima el inter-
ruptor gatillo. Para APAGAR la herramienta, suelte el
interruptor gatillo, que está accionado por resorte y
regresará automáticamente a la posición de apagado.
Su herramienta deberá estar funcionando a la máxima
velocidad ANTES de comenzar a cortar y se deberá
apagar sólo DESPUÉS de completar el corte. Para
aumentar la vida útil del interruptor, no lo ponga en
la posición de encendido y en la de apagado mientras
esté cortando.
Fig. 5
Fig. 6
Summary of Contents for SPT79A
Page 53: ...53 Notes Remarques Notas ...
Page 54: ...54 Notes Remarques Notas ...
Page 55: ...55 Notes Remarques Notas ...
