skilsaw SPT5007-EA, Instruction Manual

Page: 6 / 52

-6-
Assembly
ATTACHING THE LINE GUIDE WHEEL
1. Set the saw on its side on a flat surface with
the blade guard facing up .
2 . Loosen the locking bolt from the rear left
wheel by using T25 torx bit and an optional
screwdriver (Fig. 4a).
3. Remove the rear left wheel and its locking
bolt .
NOTE: Keep the original locking bolt in a safe
place in case the saw needs to be reverted back
to its original configuration.
4 . Attach the line guide wheel, the rear left
wheel and the long bolt in the order shown
(Fig . 4b) .
NOTE: The side of the rear left wheel with “SKIL-
SAW" logo should be facing out .
5 . Start tightening the long bolt by hand, then
tighten 1/2 turn using T25 torx bit .
FIG. 4a
FIG. 4b
Long bolt Rear left wheel
Line guide
wheel
Long bolt
Original bolt