skilsaw SPT5007-EA, Instruction Manual

Page: 16 / 52

-16-
Guide rods
Front support opening
WARNING
To avoid accidents always
disconnect the tool from the
power supply before cleaning or performing
any maintenance.
CLEANING THE EARLY ENTRY
ATTACHMENT
1 . Detach the early entry attachment from the
saw . The torsion spring assembly can be
kept attached to the saw .
a . First, turn the front locking bolt counter-
clockwise by using T25 torx bit to detach the
front part of the early entry attachment from
the saw .
b . Loosen the rear knob to detach the rear
part of early entry attachment from the saw .
2 . Use a brush and water to completely wash
the accumulated concrete on the early entry
attachment . Two key areas require special
attention (Fig . 14):
• The inside of the front support opening .
• Front and rear guide rods .
3 . Re-install the attachment to the saw .
4 . Verify the diamond wheel alignment within
the slot on the skid plate and adjust if neces-
sary . Refer to “Adjustements" section .
Maintenance
FIG. 14