Skil 3601, Owner'S Manual

Page: 3 / 92

3
WARNING
“READ ALL INSTRUCTIONS” — Failure to follow the SAFETY RULES
identified by BULLET (•) symbol listed BELOW and other safety
precautions, may result in serious personal injury.
GENERAL SAFETY RULES FOR BENCH TOP TOOLS
Work Area
Keep work area clean and well lit. Cluttered benches and dark areas invite accidents.
Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or
fumes.
Keep bystanders, children and visitors away while operating a power tool. Distractions
can cause you to lose control.
Store idle tools out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.
Do not leave tool running unattended, turn power off. Do not leave tool until it comes to a
complete stop.
MAKE WORKSHOP CHILDPROOF with padlock, master switches, or by removing starter
keys.
Electrical Safety
Before plugging in the tool, be certain the outlet voltage supplied is compatible with
the voltage marked on the nameplate within 10%. An outlet voltage incompatible with that
specified on the nameplate can result in serious hazards and damage to the tool.
Double insulated tools are equipped with a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to
install a polarized outlet. Do not change the plug in any way. Double insulation eliminates
the need for the three wire grounded power cord and grounded power supply.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and
refrigerators . There is an increased risk of electric shock if your body is grounded.
Do not expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an
outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged
cords immediately. Damaged cords increase the risk of electric shock.
When operating a power tool outside, use an outdoor extension cord marked “W-A” or
“W”. These cords are rated for outdoor use and reduce the risk of electric shock.
Personal Safety
Stay alert, watch what you are doing and use common sense when operating a power
tool . A moment of inattention or use of drugs, alcohol or medication while operating power
tools can be dangerous.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your
hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair
can be caught in moving parts. Roll long sleeves above elbows. Rubber gloves and nonskid
footwear are recommended when working outdoors.
Avoid accidental starting. Be sure switch is “OFF” before plugging in. Carrying tools
with your finger on the switch or plugging in tools that have the switch “ON” invites accidents.
Remove adjusting keys or wrenches before turning the tool “ON”. A wrench or a key that
is left attached to a rotating part of the tool will be thrown.