Ski-Doo Expedition LE, Operator'S Manual

Page: 65 / 163

CONTROLS, INSTRUMENTS AND EQUIPMENT
mmo2010-002-013_a
INSIDE THE STORAGE BOX
1. Retaining screw
To install storage box, make sure that
the tunnel surface is clean. Put stor-
age box within the rear rack rails.
Attach using the four screws.
Tighten to 10 N•m ± 1 N•m
(89 lbf• in ± 9 lbf• in ).
26) Anchor Points
mmo2012-009-001_a
REAR OF VEHICLE
1. Anchor points
Two anchor points are provided to se-
cure load in rear rack.
NOTICE
Do not exceed maximum
load capacity of rear rack. MAXI-
MUM cargo load is 30 kg (66 lb).
27) Drive Belt Guard
Drive Belt Guard Removal
WARNING
NEVER operate engine:
– Without shields and belt guard
securely installed.
– With hood and/or side panels
opened or removed.
NEVER attempt to make adjust-
ments to moving parts while en-
gine is running.
NOTE: Drive belt guard is purposely
made slightly oversize to maintain ten-
sion on its pins and retainers prevent-
ing undue noise and vibration. It is im-
portant that this tension be maintained
when reinstalling.
Remove the tether cord cap from en-
gine cut-off switch.
Refer to
CONTROLS, INSTRUMENTS
AND EQUIPMENT and open engine
compartment LH side panel.
Remove retaining pin.
mmo2008-003-063_a
TYPICAL
1. Retaining pin
Lift rear portion of drive belt guard then
release from front tabs.
Drive Belt Guard Installation
When reinstalling drive belt guard,
position its cutaway toward front of
snowmobile.
_______________
63