Ski-Doo 2006 RT series, Operator'S Manual

Page: 151 / 187

mmo2006-005-016_a
TYPICAL
1. Arrow pointing front of vehicle
CAUTION: Do not force or use tools to pry the belt into place, as
this could cut or break the cords in the belt.
To install the drive belt, first place belt between drive pulley sheaves.
Then, between driven pulley sheaves, finishing with bottom.
Remove drive belt installer/remover. Reinstall belt guard.
Close engine compartment.
Drive Pulley Adjustment

WARNING
Remove tether cord cap before performing any maintenance
or adjustment, unless otherwise specified. Vehicle must be
parked in a safe place, away from the trail.
General
The drive pulley is factory calibrated to transmit maximum engine
power at a predefined RPM. Refer to
SPECIFICATIONS at the end of
this guide. Factors such as ambient temperature, altitude or surface
condition may vary this critical engine RPM thus affecting snowmo-
bile efficiency.
_________________________
149