SKETCHNBUILD SNB-12A, Manual

Page: 8 / 27

6
worktable shall be a little lower about 1/10mm.
Setting the moving table, unscrew the lock screws on the four stud bolts, adjust the
worktable, tighten up the set screws, then put the rule on the fixed table to be parallel
with the moving table, if the surface is sunken, adjust the pressure screw for
compensation.
4.6.2 Adjust the saw blade to max cutting position, use it to cut out a small piece (it
may as well be MDF board) along cross-cutting guiding rule, judge if the setting of
moving table is correct through the sound difference between saw teeth cutting and
not cutting, when the uprising saw teeth passing through, there is only a little swing,
but saw teeth have noise in cutting.
Setting: loosen the mounting pieces on both ends of moving table and in the middle,
unscrew the lock nuts of stop screws for adjusting properly and then lock them,
afterward, adjust the moving table and tighten up each set screw.
4.6.3 Parallel
Check Plate Cutting
Adjust the saw blade to the max cutting position to cut a piece of 300×450mm
sample, if the setting of moving table is correct can be judged from the sound of
uprising saw teeth.
Ⅴ
. Operation of Machine
To raise or lower the saw blade: it just needs to adjust the Up/Down hand wheel on
the right side of the machine body.
To reduce or enlarge the angle: adjust the angle hand wheel in the front of machine.
Height Control Handle
Angle Control Handle