SKETCHNBUILD SNB-12A, Manual

Page: 3 / 27

1
Ⅰ
. Usage and Feature of Structure
This saw is destined to cut solid wood panel, chipboard, ABS board, PVC board,
organic glass board and other board which have the similar structure and hardness. It
is the necessary working tool for furniture production and decoration industry.
It is made of the body, sliding table, support for sliding table, fixed table, main saw
blade, scoring blade, up & down system, the transverse and vertical guide plate, etc.
The sliding table carriage is linear structure, exact and durable and made of
high-strength extruded aluminum alloy, sliding table is high in strength and won’t be
bent. With oxidation treatment, sliding table surface is beautiful and enduring.
Ⅱ
. Technical Parameter
Power Source 380V+3Ph/50HZ
Sliding Table Length 3200mm
Max. Cutting Height 80mm
Saw Group Tilting Angle 45°-90°
Main Saw Diameter 300mm
Main Saw Arbor Diameter 30mm
Main Saw Speed 4000/6000r.p.m
Scoring Saw Diameter 120mm
Scoring Saw Arbor Diameter 20mm
Scoring Saw Speed 8000r.p.m
Motor Power(Main Saw + Scoring Saw) 4+0.75kw
Diameter of Dust Suction Below the Table 100mm
Net/Gross Weight 650/750kgs
Ⅲ
. Safety Precautions
All equipment tools, especially the woodworking machinery fed manually, all will
cause a certain danger if not operated properly, therefore, it is required to comply with
the safety precautions and other industrial safety stipulations and requirements
summarized in this chapter forever.
Regulations on accident prevention:
＊
Before operation, ensure the safety and operating facilities are installed properly
without any damage.
＊
Before replacing saw blade, removing trouble and repairing, ensure the power
supply has been switched off and it is necessary to lock the main power supply
with lock for preventing accident.
＊
It is only allowed to use the saw blade and grooving saw blade supplied by the
manufacturer.
＊
Wear close-fitting work clothes, and do not wear ring, bracelet or wrist watch.
＊
The work place shall be clean, skidproof and has good illumination.
＊
Do not cut overlarge or too small workpiece that exceeds the equipment
characteristics.