SKETCHNBUILD SNB-12A, Manual

Page: 7 / 27

5
4.5.2 Installation of Sliding Table
Put the sliding table on the position of machine body, align the three set screws
with the screw holes and tighten them up.
Mount the rear stop plate, check if it is up to the requirement and adjust it otherwise.
Before start-up, check each link.
4.5.3 Electrical Connection
Only qualified electrician can install the electrical equipment, including connection
with power supply. Before electrical installation, the power supply must be cut off.
Only when the main power supply is cut off, each contact may be closed or opened.
The distribution box of panel saw is mounted on the electrical box of machine body
and has output line. There is a terminal box on the side and it only needs to connect
according to the mark.
Electrical Box Terminal box Running Direction
After finishing connection of power cord, start the machine just a little to check the
running direction of main saw motor, if it is necessary to correct, just change the
direction of two cord ends, and write the running direction down on the saw blade
cover with arrow.
4.6. Adjustment after Installation
In final assembly, the basic settings have been done in the factory. But adjusting the
basic settings of machine is necessary because of disassembly, transportation and
assembly on site.
4.6.1 When adjustment, make the sliding table slide smoothly from one end to the
other and can be made slide with a little force from
stationary state.
Check the moving table, put a rule on the moving table, move the moving table to
the middle position and move the moving table backward and forward, the aluminum