skcinc.com
Form 37165 Rev 200217
Page 11
Replacing the Screen Cover
1. Remove the two screws from the top of the screen cover mounting block.
2. Lift off the screen cover and mounting block.
3. Align and press-fit the mounting block onto the new screen cover posts (i.e., with the underside of the
mounting block facing up and its straight edge facing away from the cover). Rotate the mounting block away
from the screen cover until it is stopped by the inside edge of the screen cover.
4. Align the screen cover/mounting block with the holes in the top of the belt clip/top pump case.
5. Gently insert the two screws through the mounting block into the belt clip. Tighten until snug.
6. Ensure that the screen cover closes properly.
Replacing the Belt Clip
1.
Remove the screen cover.
a. Remove the two screws from the top of the screen mounting block.
b. Lift off the screen cover and mounting block.
Note
: Do not remove the two lower hex nuts from the
main case.
2. Remove the screw from the bottom of the belt clip and pull the screw through the opening in the clip.
3. Lift the belt clip away from the pump. Ensure that the hex nut in the top of the case does not fall out.
4. Push the new belt clip into place until it fits snugly.
5. Gently insert the belt clip screw through the opening in the belt clip and into the pump case. Tighten the
screw until engaged. Do not tighten completely.
6. Replace the screen cover.
a. Place the screen cover and mounting block so that the two holes are aligned with the holes in the
top of the belt clip. Insert the two screws into the mounting block and tighten until snug.
b. Ensure that the screen cover closes properly.
7. Tighten the screw under the belt clip until snug.
Replacing the Inlet Housing and/or Inlet Filter
1. Remove the four screws from the inlet housing.
2. Pull the inlet housing away from the pump.
3. Remove the O-ring and filter.
4. Insert the new or existing filter and O-ring into the inlet recess. Ensure that the O-ring is fully flat.
5. Align the new or existing inlet housing with the inlet recess.
6. Insert the four screws into the inlet housing. Tighten the screws only until the gap between the inlet housing
and pump is closed.
TROUBLESHOOTING
If the pump is not responding to touch or the pump screen displays uncommon characters, remove and reinstall the
battery (
see Replacing the Battery Pack
). If these problems persist, contact SKC.
Pump Service
Pumps under warranty should be sent to SKC Inc. for servicing. See Limited Warranty and Return Policy.
User may replace external components such as the inlet filter, battery, screen protector, and/or belt
clip. Service must be performed by SKC to maintain performance and intrinsic safety rating.
Warranty is void if pumping compartment is opened by user
.
