skcinc.com
Form 37165 Rev 200217
Page 3
Reading Charge Status on Cradle LED
The left LED on the charging cradle indicates battery status. Observe the LED steadily for > 5 seconds.
LED Action
Charge Status
Red
steady
Charge in progress
Red
3 sec
Green
1 sec
(Pattern
repeats)
Approximately 75% charged
Green
steady
Charge completed/trickle charge
Notes and Cautions
•
Power off pump before removing battery.
•
Use only the SKC charging cradle Cat. No. 220-800 or 220-900 for pump.
•
Failure to follow warnings, notes, and cautions may cause injuries and voids any warranty.
•
WARNING: Substitution of components may impair intrinsic safety. AVERTISSEMENT: La substitution de
composants peut compromettre la Sécurité Intrinsèque.
•
CAUTION: The battery used in this device may present a risk of fire or explosion when heated above 212 F
(100 C) or incinerated. Replace battery with SKC Battery Pack model P75718 only. Use of another battery may
present a risk of fire or explosion.
•
WARNING: To prevent ignition of a hazardous atmosphere, batteries must only be changed [removed and
replaced] in an area known to be non-hazardous. AVERTISSEMENT: Afin de p
révenir l’inflammation
d’atmosphères dangereuses, ne changer les batteries que dans des emplacements désignés non dangereux.
•
Maximum charge input voltage is U
m
= 12 V
•
CAUTION: Risk of Fire and Burns. Do Not Disassemble, heat above 212 F (100 C), or incinerate. Keep battery
out of reach of children and in original package until ready to use. Dispose of used batteries promptly according
to [all state and] local recycling or waste regulations.
•
User may replace external components such as the inlet filter, battery, protective screen cover, and/or belt clip.
Service must be done by SKC to maintain performance and IS rating. Warranty is void if pumping compartment
is opened by user.
For more information on SKC pump lithium-ion (Li-Ion) battery packs, visit
skcinc.com/catalog/pdf/instructions/1918.pdf
Turning Pump Power On/Off (
Figure 1
)
Turn on:
Press and hold briefly the power on/off button on the side of the pump. A
startup screen will very briefly display all status indicators, followed by the firmware
version (
right
) and then the set/calibrate flow screen or sampling screen showing
elapsed time from a previous run.
See Using the Operation Screens.
Turn off:
Press and hold briefly the power on/off button on the side of the pump.
The screen will turn off.
Note
: A non-running pump will shut off automatically after
60 seconds of inactivity but will hold the elapsed time from the last operation until
the timer is reset.
Note
: The on/off button also locks and unlocks the touch pad and dims the screen during sampling (see
Options/Modes during Sampling)
Firmware version is displayed for 3 seconds
.
