28
Horizontal stabilizer (2) in the front
Take the front horizontal stabilizer (No.2) and connect this with two raised head-socket screw (81),
four U-panes (8), two spring washers (7) and two cap nuts M8 (20) to the carrier section of the main
frame (1).
Horizontal stabilizer (19) at the back
Take the back horizontal stabilizer (19) and connect this with two raised head-socket screw (81), four
Upanes (8), two spring washers (7) and two cap nuts M8 (8) to the carrier section of the main frame (1).
Ensure that the curved U-panes (8) completely cling the surfaces of the horizontal carrier profile of the
main frame.
Connect the slide rails (3) left and right
Slide/push the slide rails (3) with the transverse lying angle profile under the horizontal stabilizer (19).
Take one of the spring washers (7) and one of the curved U-panes (6), and insert this to any one of the
attached raised head -socket screw (9A). Then pass this raised head -socket screw (9A) horizontally
through the stabilizer (19) till it tightly screws the raised head -socket screw (9A) in the given thread in
the slide rails (3).
Repeat this process with the second slide rail (3).
Next, insert the raised head -socket screw (9B) to a spring washer (7) and a U-pane (8) and thus screw
the slide rails (3) from below to the horizontal stabilizer (19).
Between the slide rails (3) at the other end, please assemble the separators (18) with one of the raised
head -socket screw (9C), a spring washer (7) and a curved U-pane (6). Then insert this horizontally
through the slide rails (3) till it can tighten this in the thread of separators (18).
ASSEMBLY INSTRUCTION MANUAL
Summary of Contents for JUPITER Series
