WARNINGS
Failure to read and understand the information provided in this manual may result in personal injury
or death, damage to the product or product failure. Please read each section in its entirety and be
sure you understand the information provided in the section and related sections before attempting
any of the procedures or operations given.
Failure to follow these precautions could result in serious injury or death.
Keep these instructions with warranty after installation. This product must
be installed in accordance with National Electrical Code, ANSI/NFPA 70 so
as to prevent moisture from entering or accumulating within the controller
housing.
ELECTRICAL SHOCK HAZARD
A qualified service person must install and service this product
according to applicable codes and electrical schematics.
Disconnect power prior to servicing any equipment.
EXPLOSION OR FIRE HAZARD
Do not use this product with flammable liquids. Do not install
in hazardous locations as defined by National Electrical Code,
ANSI/NFPA 70.
•
Do not connect power to this equipment if it has been damaged or has
any missing parts.
•
Do not install in areas with: excessive or conductive dust, corrosive or
flammable gas, moisture or rain, excessive heat, regular impact shocks,
or excessive vibration.
SJE Rhombus
®
1 Type IFS Operation Manual
Warning: Users must read this manual and understand controller operation before changing any settings. Entering
incorrect settings may result in damage to equipment.
If the controller was shipped pre-installed in a control panel, some default values may have been changed at the
factory in order to properly test the control panel operation. The user must adjust the settings to the requirements
of the installation.
The user should always keep a record of the settings before making changes, in case there is a need to revert to
previous settings. The user should also record all settings changed for use in programming a new controller in case
a replacement is ever needed.
Always thoroughly test controller operation in the installed configuration to verify user settings.
