sitrex TR/11, Assembly, Use And Maintenance

Page: 34 / 40

33
Step 21
Connect the eye end of hose 2 to cylinder Y at point F using washers 5 and the
screw-type coupling 4.
Connect the eye end of hose 3 to cylinder Y at point G using washers 5 and the
screw-type coupling 4.
At this point do not fully tighten the screw-type coupling 4.
Secure the hoses to arm C at the positions shown using collars 8, then to arm D
and lastly to the drawbar E.
Before fastening everything with plates 9 and bolts 10, place supports 8 one on top
of the other so as to create another fastening point for hose 1.
Check that hoses 2 and 3 follow a line that is as even as possible and that they
don’t have any tight bends.
Connect the eye end of hose 1 to cylinder X at point A using washers 5 and the
screw-type coupling 4.
At this point do not fully tighten the screw-type coupling 4.
Check that hose 1 follows a line that is as even as possible and that it doesn’t have
any tight bends.
Fasten hose 1 to arm B in the positions shown using collars 6 and bolts 7.
Next following the line of the hose secure it to arm C at the position shown with
collars 8, and then to arm D and lastly to the drawbar E.
At this point, with the line of the hoses established, all the collars 8 can be fully
tightened with plates 9 and bolts 10, and then the screw-type couplings 4.
Lastly insert washers 11 and attach the quick-release couplings to hoses 1, 2 and
3.