BA_ST_DSG-D_EN_36-21.docx
7
Produce wrong mitres
To produce incorrect mitres, the DSG-D has a patented
printed scale that makes it easy to set the correct angle for
the wider and narrower workpiece at the same time.
The procedure is very simple.
Example:
1.
Measure the width of wider workpiece
(e.g. 180 mm)
2.
Measure the width of narrower workpiece
(e.g. 100 mm)
3.
Calculate factor
𝑤𝑖𝑑𝑒 𝑑𝑖𝑚𝑒𝑛𝑠𝑖𝑜𝑛 180
𝑛𝑎𝑟𝑟𝑜𝑤 𝑑𝑖𝑚𝑒𝑛𝑠𝑖𝑜𝑛 100
= 𝐹𝑎𝑐𝑡𝑜𝑟 1,8
4.
Turn the turntable as shown in
Figure 7 with
the large magnifying glass (
L
) to a factor of 1.8
and clamp it tight.
This automatically results in the correct angle to the saw
blade for the narrower workpiece (
S
) on the left side of
the DSG-D and for the wider workpiece (
B
) on the right
(refer
The corresponding sides for the narrow and wide workpiece
are also shown graphically on the turntable plate.
Figure 7: Set factor by scale
Figure 8: Angles for wrong mitres
Table for length compensation on the double-sided mitre fence
Using the table (refer to section
2.5) the length compensation dimension can be set in addition to the angles
printed on the scale of the mitre fence (refer to
Example:
If a tip dimension of 350
mm is to be set for an angle of 17.5°,
the length compensation results in
the value of 29.0 mm according to
the table on the next page. This value
must now be added to the value 350
mm (
≙
35 on the length scale). Thus
the 0 on the scale of the stop rail
must now be set congruent with 37.9
(
≙
379 mm) on the length scale.
Values with a minus (marked
red
in
the table) are to be subtracted from
the tip dimension.
Figure 9: Length compensation via table
L
B
S
37.9
