Siruba ASC-TBH100A, Manual, Page: 64 / 65

32
C. Fault Repair
1. Spindle overload.
Touch-screen Alarm spindle overload, at this time check whether the
needle resistance is too large.if there have resistance, you should to
eliminate the resistance factor
，
if not
，
open the lid of the electronic
control box, record the servo driver (installed at the top of the box) on
the alarm lights on the situation (take note), contact the relevant
personnel.
2. Touch screen and motherboard communication interrupt.
Touch-screen display data transmission and can not operate, or in the
signal detection interface in real time display signal status (can be
manually rotating the main axis in this interface, observe the spindle code
changes), in this case, the shutdown needs to restart to restore
communication.
3. Back to origin failed.
Failure to reset will cause a crash. In this case, observe the action of the
mechanical back zero, see which step after the stop, according to the
order of normal reset action, check the sensor or solenoid valve of the
failure action. After the exclusion, reset again.