28
Sedan/Coupe With the Antenna Placed at the Rear of the Roof:
1.
Feed the antenna cable from the antenna underneath the rubber
molding around the rear window . Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the rear window
and tuck the antenna cable underneath the molding . Route the antenna
cable around and down the window to the lowest point . If your rear
window does not have rubber molding, we recommend consulting a
professional installer .
2.
Route the antenna cable out of the window molding and into the
rubber weather stripping around the trunk opening . Lift the weather
stripping from the opening and tuck the cable inside it, then replace
the weather stripping . To avoid sharp bends in the cable, run the cable
inside the weather stripping for a few inches, then remove the cable
from the weather stripping inside the trunk . Keep the cable away from
hinges, gears, etc ., that could damage it .
3.
Route the cable out from the rubber weather stripping and along the
trunk wall . Continue routing the cable into the vehicle cabin through a
conduit or along an existing wiring harness .
4.
Route the cable through the
main cabin area under the
interior trim, towards the front
of the vehicle . Use a blunt
plastic putty knife or similar
blunt tool to lift the plastic trim
just enough to tuck the cable
under underneath . Avoid side
airbag locations on back pillars
and above the doors . Airbag
Vehicle Installation
