Italy 100 cutter
Use and Maintenance Manual Ver. 1.1
20
5.4
C
ONNECTING TO THE MAINS
WARNING
All the connections to the mains must be made with the power line
disconnected and by qualified and expressly authorised staff in full compliance
with the regulations in force
Check that the mains voltage and frequency correspond to those indicated on the
machine identification plate or in the wiring diagram. Check that the mains power
supply is equipped with an automatic protection switch to safeguard the operator from
insulation leaks and/or direct contacts (differential magnetothermal switch). After
checking all the above, connect the electrical plug of the cutter to the power socket.
5.5
F
ILLING THE COOLING WATER TANK
The machine is equipped with a
tank to contain the water used for
cooling the diamond disc. A pump
positioned and completely
immersed in the tank draws the
water from the tank and pushes it
through a flexible hose onto the
cutting blade. The water will fall
back into the tank by gravity. The
tank is equipped with a draining
hole and a tapered rubber plug
provided with the machine: to
empty out the tank before moving
the machine, pull out the rubber
plug.
The tank must be filled before
use. To this end, check that the plug is securely inserted in the drain hole and then pour
in water until the pump is completely submerged. Finally, check that the flexible water
delivery hose is securely fitted, one end to the water outlet point of the pump body and
the other end to the hosetail union on the front of the disc guard. During use, check
that the water level in the tank is always such that the pump remains submerged and
top up with water if necessary. The pump and hence water delivery is activated when
the machine is turned on.
