Italy 100 cutter
Use and Maintenance Manual Ver. 1.1
30
7.4.3 Poor cutting performance
In some cases, a disc may partially become less sharp even though it is not completely
worn out; in these cases the disc must be sharpened.
To sharpen the cutting disc using the
SIRI disc sharpening stone,
turn on the cutter
and bring the stone in contact with the diamond crown of the disc, then turn off the
cutter and wait until the disc stops rotating.
Alternatively, you can make a few cuts on one of the materials listed below, which will
sharpen the disc, however, not perfectly:
Serena stone
Refractory stone
Pumice stone
Abrasive discs
During sharpening, cool the disc with water as for any other cut.
7.5
P
LACING THE CUTTER OUT OF SERVICE
The cutter is not polluting or harmful to the environment, however, during installation,
maintenance or decommissioning, waste is produced, which, if not disposed of properly,
is harmful to the environment.
Always aim at protecting the environment.
Packaging:
this is household waste that can be disposed of at dumping grounds
without creating a major risk to man and the environment (e.g. wrappers, cardboard
boxes, plastic, etc.)
Deteriorated or obsolete machinery and equipment:
this is special waste to be
disposed of separately by type.
