SineDigital,Inc.
Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 16
(2) channel
AccessPoint> channel
SSID (current: wavecast) : testssid
Automatic Channel Configuration Enable? (CURRENT:enabled) [Y/N]:
Channel (current: 2) [1~13] : 9
Change the configuration options as below.
SSID : testssid
Channel : 9
Proceed? (Y/N)
Changes will effect after save and reboot.
Reboot the system with "[~@home]" command.
AccessPoint> save
Configuration saved successfully
AccessPoint>
This command is used to configure the SSID and channel used by the MW-1500AP(H). Typing
this command at the prompt will display the current SSID followed by the message:
Automatic Channel Configuration Enable? (CURRENT:disabled) [Y/N]
The current status of the automatic channel function is displayed within the parentheses "( )".
The line also asks for an input of Y (yes: enable the automatic channel function) or N (no:
disable the automatic channel function).
If enabling the automatic channel function, the AP will, the next time it reboots, automatically
scan the vicinity then decide on the most appropriate channel. If disabling the automatic
channel function, you must manually select the channel the MW-1500AP(H) will operate in.
