SineDigital,Inc.
Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 18
(7) help
This command displays a list of some configuration commands available in the MW-1500AP(H)
as shown in the figure below. Please refer to each command's section for detailed explanation.
AccessPoint> help
------------------------ Help ----------------------------
aaa AAA configurations
channel Channel set
csmac Close System(MAC filtering) TABLE [show/add/del]
dhcp DHCP Client setup
dhcpr DHCP Relay setup
dhcpserver DHCP Server setup
help Show help
home Home directory
iapp Iapp config
ifconfig Interface IP, subnet config
power WLAN power setup
redirect WEB Redirection configurations
rf RF setup
show Show configurations
siteinfo AP installation site information
snmp SNMP agent and trap configurations
sntp SNTP configurations
ssidprotect SSID protection setup
syslog Syslog [enable or disable]
version Version number
write AP configuration save
AccessPoint>
(8) http
This command configures the HTTP aspect of the MW-1500AP(H) and the following are the
possible commands.
http
: Displays the current configuration status of the MW-1500AP(H)'s HTTP function and a
list of related commands.
http [enable / disable
]
: Enable/disable operation of the MW-1500AP(H)'s HTTP.
http port <number>
: Defines the port the MW-1500AP(H) will use for HTTP (factory default
is 80).
http filter [enable / disable]
: When enabled, only the clients with the specified IP addresses
are able to configure and manage the MW-1500AP(H) via HTTP. When disabled, any client
will be able to configure and manage the MW-1500AP(H) via HTTP.
http permit add <first IP> <last IP>
: Adds to the MW-1500AP(H)'s memory the IP address
range that will be allowed to configure and manage the MW-1500AP(H) via HTTP by
specifying the first and last IP addresses of that range. You can add up to five IP address
ranges.
http permit del <number>
: Deletes the IP address range of the specified index number from
the MW-1500AP(H)'s memory.
