![background image](http://html.mh-extra.com/html/simu/2008924/2008924_translation-of-the-original-manual_1279426007.webp)
7/36
Installation of the declutching system:
INSTALLATION
1
PROGRAMMING THE RADIO MODULE ON AN EXISTING INSTALLATION
2
The unit must be installed vertically:
Vertically
Horizontally
1 - Mark the position of the holes using the SCALE TEMPLATE (page 33) and drill.
2 - Pass the declutching cable through the hole
provided for this purpose. Make
sure that the flexible sleeve rests against the bottom of the unit.
3 - Attach the declutching unit to the wall with appropriate fasteners through the
holes
.
①
Fit the handle.
②
Position the tensioner on the cable.
③
Position the tensioner in the handle.
④
Tighten the declutching cable by hand until you feel resistance without disengaging the motor.
⑤
Tighten the M4 screw of the cable clamp to the torque of 3.2 Nm.
⑥
After making 3 releases, take up the play created using the tensioner nuts, without disengaging the motor.
⑦
Cut the declutching cable 2 cm from the tensioner.
i
If necessary, you can tighten the declutching cable again by repeating step
⑥
.
1
2
PROG 1 s.
PROG 3 s.
Transmitter already
programmed
New transmitter
①
From the individual command transmitter which is already programmed, open the receiver's memory:
Press the PROG
button of the transmitter for about 3 seconds
—>
The motor responds with a "short rotation
".
②
Then validate the operation from the new transmitter to be programmed:
Press the PROG button
of the new transmitter
for about 1 second —> The motor confirms the setting with a "short rotation".
- To delete a transmitter from the motor's memory: perform operation
①
with a programmed individual transmitter and the
operation
②
with the transmitter to be deleted.
Note:
The number of
programmable transmitters
per installation is limited to 12.
ATTACHING THE RADIO MODULE
3
Screw the module into the unit using the supplied screws, with a maximum torque of 0.9 Nm
②
⑦
③
2 cm
⑤
⑥
④
①
EN-