Simrad EQ44, Manual Manual

Page: 19 / 102

Automatic input source setup
Interface has not been set up!
To start automatic input
source setup, make sure that
all connected products are
turned ON, and press ENT.
Start
ENT
∆
∆
EQ44/54 Fundamentals & initial start-up Chapter 2-7
2.5 Initial start-up
When starting up for the very first time, the first time after loading
a new software or after a master reset: Make sure that all hardware
installation and electrical connections are completed in accordance
to the installation instructions.
PWR
Press and hold the [PWR] key until you have a picture on the screen
The system will perform a software update and check for com-
munication activity. When finished, a new start-up window will be
presented on the screen:
After making sure that all connected products are turned ON:
ENT
Press [ENT] to start automatic input source setup , - if a new product
is connected later on, refer to section 10.4 Interface setup.
New window: Automatic input source setup listing Data type, Group
and Source of connected units.
ENT
Press
[ENT]
to continue
PAGE
Press [PAGE] to scroll through a quick guide which informs of the
use of the keys and where you can enter owner’s setup, etc.
- the quick guide is also accessible via [MENU], [7], [6].
ENT
Press [ENT] when ready to assume normal operation
- go to [MENU], [7], [3] if you wish to make adjustments to the
interface setup.