Simpro Multi-Tip MT1200, User Manual

Page: 33 / 48

User Manual // Simpro Multi-Tip®
Original Instructions // English // v83.0 // October 2022 // Page
32
4. Tie the pallet and machine into place using marked tie-down points and strops rated
to at least 1000kg. Make sure it is securely restrained from moving in any direction.
4.4.1 Horizontal transport
It is not recommended to transport the Multi-Tip in horizontal position as this can cause
hydraulic fluid leaks, chain derailments and other damage. However, if the machine must be
laid over for transport, the additional procedures must be followed:
1. eve h c f e ks, e e b e ‘ s ’ g s be f e he oil
tank ce f he s ‘b e he ’ g. A e ve , he f s be e .
2. To maintain positive tension on the chains and prevent jams, the cradle must be tied
or strapped into the fully-lowered position.
3. To minimise the likelihood of damage to the frame and guarding, the machine must
only be lain over onto its front (tipping) face.
4. Once the machine has been unloaded and stood back upright, the breather plug
must be re-fitted before the machine is operated.
If he ch e s e e w h he ‘ s ’ g s ce, v c w f s e
the oil tank, potentially causing it to rupture or collapse.
4.5 Storage
If the machine is not to be used for a period of two months or more, it should be stored in a
clean, dry place with good ventilation, at temperatures not below 0
℃
. Before placing the
machine into storage, carry out the following procedure:
1. Carry out two full tipping cycles, then lower the cradle to the ground.
2. Clean the machine thoroughly as per §3.2 .
3. Apply a thin layer of silicone lubricant to exposed surfaces of moving parts.
4. Charge the batteries (if fitted) and lubricate the electrical contacts.
5. Depress the Emergency Stop (if fitted) or turn the battery isolator switch OFF.
6. Remove the key and store it in a safe place.