Simpro Multi-Tip MT1200, User Manual

Page: 18 / 48

3. Care and Maintenance
The Multi-Tip is designed to give many years of service with minimal maintenance. In the
event a fault or malfunction does occur, refer to the Quick Troubleshooting Guide in
§3.1
before contacting your Simpro agent for support.
Contact your Simpro agent if repair or service work is required.
All repair and service work must be carried out by qualified personnel.
Replacement parts must be supplied by Simpro or an authorized Simpro agent, and must
be of the same design and specification as the original parts.
A detailed Service Manual giving specific testing and repair instructions is available on
request from Simpro.
3.1 Quick Troubleshooting Guide
Please refer to the Quick Trouble Shooting Guide below before requesting technical support.
Problem Possible Causes Remedy See also
The machine
will not lift
bins, and the
motor does
not run
Flat battery
The battery needs to be charged if
voltmeter reads less than 24.0V.
§2.4
Battery 0250050004
Tripped circuit
breaker or fuse
Wait 1-2 minutes for circuit breaker to
reset (or replace blown fuse). Avoid
operating machine with flat battery.
§3.4.7
Breaker 0790050374
Fuse 0790050107
Faulty up/down
switch or wiring Check and rectify – replace if
necessary.
Up/Down switch
0790050454
Faulty motor
solenoid (battery
models only) The motor solenoid should click when
the UP and SAFETY buttons are pressed
– if not it may need to be replaced.
24V Motor solenoid
0880050015
The machine
will not lift
bins,
although the
motor runs
Bin too heavy
Remove material from bin to reduce
the weight. §1.4
§3.3.1.1
Pressure-relief
valve set too low Contact your agent for instructions on
adjusting the pressure setting.
§3.7.2.2
3-phase motor
running in reverse Swap two of the phase wires in the
power plug (3-phase machines only)
§3.5.1
Cradle will
not come
down from
the fully
raised
position
Mast sliding block
jamming in mast Lightly lubricant inside of mast, slider
block and rollers with silicone spray
§3.3.2.2
Mast block
0090120001
Lift ram jamming Contact your agent for support.
§3.3.2.2
MT1600 Ram
0230090001
Faulty up/down
switch, wiring, or
lowering valve
coil we g v ve sh ‘c ck’ whe he
DOWN and SAFETY buttons are
pressed
– if not, check the up/down
switch, wiring and lowering valve coil.
§3.3.2.1
Up/down switch
0790050454
24V Lowering valve
Coil 0250090067
Cradle
jamming
part-way
down
Mast bent or
damaged Check and straighten – replace if
necessary.
§3.3.2.2
Tipping guide flap
sticking or
damaged
Check and rectify – replace if
necessary.
§3.3.2.2
Tipping guide flap
0230040001