User Manual // Simpro Eurover
Original Instructions // English // v34.0 // April 2022 // Page
14
4.
Test the machine to see if the cradle now lifts correctly. Run the machine through
several complete tipping cycles to ensure the problem has been fully resolved.
5.
If the machine is still not operating correctly, contact your agent.
3.5
Electrical System
The Eurover is driven by a 3-phase 2-pole electric motor, which is connected to the lifting
chain via a gearbox. A transformer provides 24VDC correct to the control circuits.
The motor runs only when the cradle is lifting or lowering.
3.5.1
International conformance
The specifications of 3-phase machines may differ depending on the standard voltage and
frequency of 3-phase mains power in the intended country of use. In regions where 3-
phase/~400VAC/50Hz power is standard (primarily in Europe, Australasia, and Asia) the
Eurover motor is driven directly by the 3-phase current in delta configuration.
A list of 3-phase power standards in different countries and territories may be viewed
here:
https://www.worldstandards.eu/three-phase-electric-power/
Connecting the Eurover to a power supply for which it is not designed may damage the
motor and electronic components. Consult an electrician if you are unsure.
3.5.2
Appliance inlet
The Eurover is fitted with a 3P+N+E 16Amp appliance inlet with IP44 ingress protection. This
allows the machine to be operated using a regular 3-phase extension lead.
The Eurover is fitted with a phase-rotation relay, so it will not operate if the AC phase
polarity of the input power is inverted. This can be corrected by switching two of the
phase wires in the power plug as set out in
3.5.3
Emergency stop
The Eurover is fitted with an EMERGENCY STOP button on the control panel. It is engaged by
depressing the red button, and disengaged by pulling the button outwards.
When engaged, the EMERGENCY STOP isolates all of the
machine’s
electrical circuits from
the power supply. It should be engaged, and the mains power lead disconnected, before
any covers are removed from the machine.
3.5.4
Motor
The Eurover is fitted with a NORD 1.1kW AC
electric motor, which drives the lifting chains
through a gearbox.
The motor accepts a variety of different
input voltages and frequencies.
The motor rating plate is shown at right.
