1.
Without loading a bin into the machine, press the RAISE button on the control panel.
The cradle should begin to lift.
a.
If the cradle does not move, it is likely that the AC phase polarity of the input
current is inverted. Carry out the procedure in
2.
Insert a 200L Eurobin into the cradle and carry out a complete tipping cycle to check
that the upper and lower limit switches are adjusted correctly. The motor should stop
at the top of the cycle when the bin is at about 40° degrees, and at the bottom of
the cycle when the bin touches the ground.
a.
If the motor does not stop in the desired position, adjust the position of the two
limit switches as necessary.
3.
Conduct another tipping cycle with an empty Eurobin, closely observing the roller
and tipping track for jamming, unusual sounds, or misaligned operation. Adjust or
realign components as necessary.
4.
Conduct a tipping cycle with a full bin to validate the installation. The complete
tipping cycle should take approximately one minute. If the bin does not completely
empty, the top limit switch can be adjusted to change the tipping angle, per step 2.
Once all checks are complete, the Eurover may be placed into service.
4.2
Moving
The Eurover with mobile base unit can be easily moved using the grab-handles provided. To
ensure stability the cradle should be positioned 100mm off the ground when moving.
On a hard, flat surface, the mobile Eurover can be moved by a force of approximately
100 Newtons at a height of 1.6 metres.
Extra care should be taken when moving the machine on sloping ground.
4.3
Lifting
Carry out the following procedures when lifting the Eurover:
1.
Check that the lifting equipment is in good condition and has a safe working load of
at least 500kg.
2.
Connect a chain or sling from the lifting equipment to the lifting eye at the top of the
Eurover mast.
3.
With one person operating the lifting equipment, and another watching for
obstructions and steadying the load, slowly lift the Eurover until the base is a short
distance off the ground.
4.
Move the machine to the desired location and lower it into position. If the machine is
being laid over for storage or transport, place it onto its side with the mast lowermost.
Standard Eurover models weigh 350-400kg. Always verify the weight of the machine on
the rating plate, and check that the lifting equipment to be used has sufficient capacity.
Never stand or reach underneath the machine while it is being lifted.
