SimonsVoss WaveNet, Manual

Page: 161 / 210

Hardware reset of external LockNodes
You can reset WaveNet Manager-enabled LockNodes (recognisable by
WN
M in the article number):
1. Disconnect the LockNode from the power supply or remove the batter-
ies.
2. Wait for about 20 seconds.
3. Press and hold the Init button.
4. Reconnect the power supply or replace the batteries.
9
LED lights up constantly red.
5. Release the Init button while the LED is constantly red.
9
All WaveNet information in the LockNode is deleted.
You can re-integrate the LockNode into your WaveNet (see WaveNet
manual).
Hardware reset of internal LockNodes
Internal LockNodes are completely reset if you install the LockNode in a
lock of another locking system.
1. Remove the LockNode (see manual/quick guide for the LockNode or
locking device).
2. Reinstall the LockNode in a programmed lock of another locking sys-
tem.
9 Lock beeps/flashes four times.
9 LockNode is reset.
You can then remove the LockNode from the lock of the other locking
system. You can then use the LockNode again in your WaveNet.
5.5.5.2 RouterNodes
NOTE
LockNodes cannot be reached after resetting
If you reset a RouterNode, you will not be able to reach its LockNodes af-
terwards.

Reset LockNodes connected to the RouterNode beforehand (see
LockNodes [
}
143]
).
Reset RouterNodes have the default radio configuration:
WaveNet (Manual)
5. WaveNet Manager
161 / 210