Simons Voss Technologies SmartHandle AX, Manual

Page: 148 / 178

13 Battery replacement
13.1 Instructions on battery replacement

Only specialists may replace the batteries.

Do not touch electronics/components; do not allow them to come into
contact with oil, paint, moisture, alkali or acids.

Only use batteries approved by SimonsVoss.

The batteries used may pose a fire or burn hazard if handled incorrectly.
Do not recharge, open, heat or burn these batteries. Do not short-circuit!

Dispose of old or used batteries correctly. Store out of children's reach.

Check the polarity of the batteries.

The batteries will have discharged to roughly the same level. That is
why you must replace all batteries.

Do not touch the contacts on the new batteries with your hands when
replacing the old ones. Use cotton gloves free of fat or grease.

When replacing the batteries, make sure that no pressure is applied to
the electronics or that they are not damaged in any other way.
13.2 Procedure
The batteries are located at the SmartHandle AX under the cover. You
need the SimonsVoss fitting tool to change the batteries.
1. Place the SimonsVoss fitting tool in the recess provided for it in the
cover. These are found on the side away opposite the electronics.
2. Push the SimonsVoss fitting tool into the recess until the cover springs
out.
3. Pull the cover down until it comes free with a click.
4. Remove the cover.
SmartHandle AX (Manual)
13. Battery replacement
148 / 178