20
7. o
peration
i
nStructionS
7.1 Using Pressure Washer
1. Start the engine.
2. Install appropriate spray nozzle.
3. Adjust gun collar to desired setting for application.
4. Release the trigger safety lock if it is locked.
5. Purge the air by squeezing the trigger on the gun until
there is a steady stream of water.
6. Position the tip of the wand 15-20 cm (6-8”) away from
the surface to be cleaned, at an angle appropriate to the
spray nozzle used (0˚, 15˚, 25˚ or 40˚).
7.2 Shutting Down and Cleaning Up
a
(Skip this step if you are not using detergent.)
After cleaning with detergent, fill the detergent tank
with clean water. Spray water at a low pressure for
one minute, so that all detergent is flushed out of the
system.
s
Stop the engine.
d
Turn off the water supply and disconnect the water
supply from the water inlet.
f
Pull the gun trigger to release any remaining water
pressure.
g
Engage the trigger safety lock on the spray gun and rest
the gun on lower and upper supports.
WARNING
Turn off the water supply and pull the trigger to depressurize
the unit. Failure to do so might result in personal injury due to
discharge of pressurized water.
7.
3
Using Spray Nozzle
This pressure washer comes with 5 different nozzles that
can be installed on the stainless steel wand. The spray
pattern is adjusted by installing the appropriate spray
nozzle.
0
º
15
º
25
º
40
º
Detergent
•
0° (Red):
Thin and powerful stream of water
for difficult stains and debris
removal.
•
15° (Yellow):
Thin-angled spray for detailed
cleaning.
•
25° (Green):
Medium-angled spray for detailed
cleaning.
•
40° (White):
Large pattern for wider cleaning
applications.
•
Detergent (Black): This nozzle must be used when
applying detergents with the
on-board detergent injection
system. Applies detergents in low
pressure only.
Installing spray nozzle to the quick-connect
coupler:
1. Pull the coupler ring back and insert the desired nozzle.
2. Release the coupler ring to lock it back in place.
Operating Instructions
6-8” (15-20 cm)
XG01_3200PSI_E.indd 20
2016-12-05 4:11 PM
