User manual for - FLOW METER SPI-N118
7.
DEVICE PROGRAMMING
The device menu allow user to set all parameters connected to operation of
measurement input, control modes, critical situations behaviour, communication via RS-485
and access settings. The meaning of the particular parameters is described in paragraph
MENU DESCRIPTION
.
Some of the parameters can be accessed without menu entering (quick view mode).
If current flow is displayed (LED named
“
Σ
”
is off) or batcher counter value (LED named
“
Σ
”
is
pulsing) user can check main thresholds values and
number of batches
(which indicates how
many times batcher was started). After pressing
[^]
or
[v]
button, name of the threshold (e.g.
”rELPr1”
) and its value or
”bAtCnt”
label and
number of batches
will be displayed on the
display in alternating mode. If
[^]
or
[v]
will be pressed in 5 sec again, the next threshold will
be displayed, else the device comes back to the measurement mode. If a
free access
is
enabled (see description of
”SECU” menu
), user can change the value of particular threshold
pressing button
[ENTER]
(see:
PARAMETERS EDITION
).
If particular parameter has been changed and confirmed in quick view mode, its
new value is displayed in alternating mode with parameter name by few seconds.
Confirmed changes may be checked or user can switch viewed parameter pressing
[^]
or
[v]
button.
7.1.
PROGRAMMING MENU
To enter main menu (being in the measurement mode) operator must to press and hold
at least 2 sec.
[ESC/MENU]
button.
If the user password is defined (see parameter
“SEtcod“
,
menu
”SECU”
), operator have to
enter correct one before proceeding to menu options . Entering of the passwords is similar to
the edition of numeric parameters
(see:
PARAMETERS EDITION
)
,
however presently editing
digit is showed only on the display, other digits are replaced by “-” sign.
After entering of last digit of the password first menu position will be displayed (if the password
is correct) or warning ”
Error
” in other case.
Pay attention when device parameters are being changed. If it is possible, turn off
controlled installation (machine).
Functions of the buttons while sub-menu and parameters choice:
Selection of sub-menu or parameter for editing. Name of selected item (sub-
menu or parameter) is displayed.
or
Operation of
[ENTER]
button depend on present menu position:
•
if the name of some sub-menu is displayed - enter this sub-menu; name
of the first parameter (or next level sub-menu) is displayed,
•
if the name of some parameter is displayed - enter the edition of this
parameter; present value of the parameter is displayed,
[ESC/MENU]
button allow user to exit present menu level and goes to upper
level menu (or measurement mode).
22
ENTER
MENU
ESC
i
!
PAUSE
ENTER
