Simex MultiCon CMC-N16, User Manual

Page: 31 / 292

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-N16
The information bar displays ( Fig. 6.5 ):
– name of the Group visible on the screen, in place of a standard name (e.g. Group
4 ). It is possible to enter a more descriptive name for clarity (for more information
see Chapter 7.14. GROUPS ),
–
group number
- number of the currently displayed Group, to change the displayed
Group
press button
[↓GROUP]
or
[GROUP↑]
in the
Navigation bar
(see
Chapter
6.3.2. Navigation bar ),
– time and date - current time and date displayed in the top right corner on the screen
can be set in General settings (see Chapter 7.7. GENERAL SETTINGS ),
– logging data indicator - located in the Information bar the logging data indicator
changes color depending on the state of logging:
•
gray color
- data logging option is not activated (to activate the data logging
option you need to enter the licence key provided by the manufacturer - see
Chapter 7.4. DEVICE INFORMATION, LICENCE, FIRMWARE UPDATE,
REMOTE DISPLAY, EXPORT MANUAL AND RENEW CONFIGURATION
), or
when the logging option is activated but disabled.
• green color - after activation the data logging option indicator changes to green
when the data logging is enabled (for more information about setting data
logging see
Chapter 7.14.2. Groups - Logging options
),
• yellow color - It is possible to log data in the device but there is less than 20%
of total free memory remaining (to clear the memory you need to move any
important data logging files and possibly the Modbus templates onto a
removable flash drive, after which remove them from the device – for more
information see
Chapter 7.3. FILES MANAGEMENT ). Also at the moment when
free memory drops below 20% a warning will be displayed on the screen.
• red color - warning about the lack of space on a memory card, meaning data
logging will not be possible until space is freed in the memory (how to remove
data and exchange data with a flash drive is shown in
Chapter 7.3. FILES
MANAGEMENT )
• alternately blinking green with a blue color - when the indicator flashes blue,
the logged data is moved to memory (Note! at this time you must not turn off the
device because it may cause a loss of recently logged data).
In order to turn off the device, especially when the data logging is ON , it is
recommended to use the safe-off device by pressing the button Safe-shutdown in
the main menu (see
Fig. 6.1
).
6.3.2. Navigation bar
Touching the screen at any place causes the Navigation bar to display (see Fig. 6.6 )
which allows the user to switch between visualisation modes, groups and to enter the menu.
31
!