Sime Brava One HE 40 ErP, Installation And Maintenance Manual

Page: 86 / 132

86
EN
TABLE OF COUNTER DISPLAYED
Type No. Description Range U/M Step
PAR c0
total no. of boiler
operating hours
0 ..
99
h x 1000
0.1; from
0.0 to 9.9;
1; from 10
to 99
PAR c1
total no. of burner
operating hours
0 ..
99
h x 1000
0.1; from
0.0 to 9.9;
1; from 10
to 99
PAR c2
total no. of burner
ignitions
0 ..
99
h x 1000
0.1; from
0.0 to 9.9;
1; from 10
to 99
PAR c3 total no. faults
0 ..
99
x 1 1
PAR c4
total no. of times
installer parameters
"ALL"accessed
0 ..
99
x 1 1
PAR c5
total no. of times
OEM parameters
accessed
0 ..
99
x 1 1
PAR c6
time unitl next
maintenance
intervention
1 ..
199
months 1
PAR c7
total no. of
calibrations
1 ..
199
x 1 1
TABLE OF ACTIVATED ALARMS/FAULTS
Type No. Description
PAR A0 Last activated alarm/fault
PAR A1 Last but one activated alarm/fault
PAR A2 Third from last activated alarm/fault
PAR A3 Previous activated alarm/fault
PAR A4 Previous activated alarm/fault
PAR A5 Previous activated alarm/fault
PAR A6 Previous activated alarm/fault
PAR A7 Previous activated alarm/fault
PAR A8 Previous activated alarm/fault
PAR A9 Previous activated alarm/fault
3.6 Checks
3.6.1 Chimney sweeper function
The chimney sweeper function is used by the qualified
maintenance technician to check the mains gas pressure, detect
the combustion parameters and to measure the combustion
efficiency required by legislation in force.
This function lasts 15 minutes and is activated by proceeding
as follows:
– if the panel (2) has not already been removed, remove the
two screws (1), pull the front panel (2) forwards and release it
from the top by lifting it
2
1
Fig. 33
– remove the screws (3) securing the control panel (4)
– move the panel (4) upwards (a) but keeping it in the side
guides (5) to the end of travel
– bring it forwards and down (b) until it is horizontal
3
a
b
5
4
Fig. 34
– close the gas valve
– loosen the screw of the "mains pressure" point (6) and connect
a pressure gauge
6
Fig. 35
– open the gas valve
– power the boiler by setting the main switch to "ON"
ON
Fig. 36