background image

Supplied By www.heating spares.co  Tel. 0161 620 6677

USER’S GUIDE

HIGH EFFICIENT COMBINATION BOILER

It is the law that all gas appliances are installed by
a competent person, in accordance with the gas
safety installation and use current regulations.
To the current Gas Safety (Installation and Use)

Regulations 1994 (as amended).

All CORGI registered installers carry a CORGI I.D.

card and have a registration number. Both should be
recorded in your boiler log book. You can check your
installer by calling CORGI direct on: 01256 732300.

1.2.1

Escape of gas

Should a gas

leak be

suspected,

contact your gas

supplier without delay.

Do NOT search for gas leaks with a naked flame.

WARNING:

This appliance must be earthed.

Do not touch or tamper with this sealed unit or

its components

1.4

1.4.1

1.

1.1

INTRODUCTION

Please carefully read information given in

the booklet to help you gain maximum
control from your appliance with minimum
trouble and cost.

1.4.2

1.1.1

Your Ravenheat Combination Boiler has
been designed to supply your Central

1.4.3

Heating and Domestic Hot Water directly

from one unit.
When central Heating is operating, the
circulation will be interrupted when
domestic hot water is being drawn off. This
will normally not affect the level of heating.

CLEARANCES AROUNDTHE BOILER

Above 125 mm
Below 100 mm

Front 450 mm

Sides 5 mm
5 mm in front when installed in a cupboard.

Minimum clearances are required for safety

and maintenance. Do not obstruct any

purpose made ventilation opening if boiler
has been fitted in a compartment.
Never hang clothes, etc., over the appliance.

USER CONTROLS

See Fig. 1

This appliance is designed to operate with
the minimum of attention by the user.
All controls are to be found on the control
panel.

OPERATING SAFETY CHECKS TO

PROTECTYOUR APPLIANCE

Before lighting the appliance check central
heating system pressure (7) is not less

than 1 bar gauge. If it is below this do not

light but consult your installer about refilling

your system as you may have a leak in the
system.

An ORANGE warning light on the control
panel warns of a flame failure of the main
burner. This can be reset manually by
pressing flame failure switch (1B).

Overheat thermostat lockout could occur due
to air or poor circulation in the boiler/heating
circuit. This can be reset manually by removing
grey cover (3) on control panel and pressing

red reset button. Replace cap. If lockout

should persist leave the appliance shut down
and consult your installer/service engineer
immediately.

Reviews: